Tuotenumero: 3345706

Thermal Grizzly Intel 1851 Delid-Die-Mate Heater

The Intel 1851 Delid-Die-Mate Heater V1 is a specially designed heating element for the Intel 1851 Delid-Die-Mate V1. The heater raises the temperature of both the CPU and the delidder to 165°C, the necessary temperature for delidding. The operation is controlled via a control unit with an OLED display, which is connected to the heater with two cables. A laptop/smartphone charger with at least 65 watts of power and a USB Type-C connector, which is not included, is required for the heater to operate. A small amount of thermal paste is also needed.

Heating element for warming the CPU
Designed for the Intel 1851 Delid-Die-Mate V1
Follow the warning instructions!
Scope of Delivery:

1x Intel 1851 Delid-Die-Mate Heater V1
1x Angle wrench
1x TG Cleaning Wipes
1x Kryonaut, 1g
Warning Instructions:

Note: When delidding with the Intel 1851 Delid-Die-Mate V1, the CPU should be heated to 165°C (the melting point of indium is 157°C) to liquefy the indium, making it easier to remove the heat spreader. This minimizes mechanical stress on the chip and helps prevent damage. Otherwise, there is a high risk that the CPU could be damaged during delidding.

Caution: delidding a CPU can be dangerous. Any damaged caused by this will not be covered by warranty. Make sure to ressearch how to before trying. 
65,96 € 52,56 € Ilman arvonlisäveroa
Edullisin toimitus (yksityisasiakkaat) 6,99 €
Tilaustuote, 9-12 arkipäivää toimitukseen

Kotelot - lisätarvikkeet

CPU-jäähdytys

Valmistaja
Tuotenumero
3345706
Malli
TG-DDMH-i1851-V1
Ean
4260711991172
Valmistajan kotisivuille

Edellä mainitut tiedot/tekniset tiedot ovat suuntaa-antavia ja valmistaja voi ilman varoitusta muuttaa niitä. Pidätämme oikeuden painovirheisiin ja ohjeellisiin kuviin. Jotkin tekstit voivat olla automaattisesti luotuja tai konekäännettyjä, mikä voi johtaa harhaanjohtavaan tekstiin.